Sales

  • Applanix POS MV SurfMaster One Equipment rental to supply an Applanix POS MV SurfMaster One. Comes in a all-in-one IMU/PCS small form factor topside, dual GNSS antennas, dual antenna cables, interface cables, software, user manual, and transit case.
  • Maximize your ROI with Applanix® POS MV OceanMaster. OceanMaster is a user-friendly, turnkey system designed and built to provide accurate attitude, heading, heave, position, and velocity data of your marine vessel and onboard sensors. Applanix POS MV blends GNSS data with angular rate and acceleration data from an IMU and heading from GNSS Azimuth Measurement System (GAMS) to produce a robust and accurate full six degrees of freedom Position and Orientation solution. All Applanix POS MV models are designed for use with multibeam sonar systems, enabling adherence to IHO (International Hydrographic Survey) standards on sonar swath widths of greater than ± 75 degrees under all dynamic conditions.
  • Trimble® SPS851 Modular GPS Receivers are ideal for semi-permanent or permanent base station setups, construction rover applications as well as marine based applications. Now heavy and highway contractors have the ideal base station to support grade checking, site measurement and stakeout. The receivers can be utilized as a rover with a controller in a site supervisors vehicle or on a pole. Modular Design Means Flexible Set Up The Trimble SPS851 receivers combine the radio and GPS receiver in a single housing. This allows contractors to secure the majority of their investment inside a site trailer or carrying case, protected from the elements and theft, leaving only the antennas outside. The antennas can now be located clear of obstructions and provide maximum radio coverage on site.
  • Innomar Compact SubBottom Profiler Equipment rental to supply an Innomar Compact Sub-Bottom Profiler. Comes with topside interface, pole mountable transducer with built in 20-meter deck cable, accessory kit, SES-WIN control software, mounting hardware, and transit cases.
  • Kongsberg M3 Sonar HF The M3 Sonar HF is a high-frequency sonar with imaging and profiling modes. It is an impressive upgrade to the original M3 Sonar, with an all-titanium construction and two-hundred percent higher resolution.
  • Kongsberg 352P MGC R3 USBL System Portable system designed for tracking ROV's, towfish, divers and other subsea objects at several thousand meters range. The system operates in SSBL mode where it measures the distance and direction to subsea transponders and computes a 3D position in local coordinates or in geographical coordinates. Built-in MGC RT inertial measurement unit for roll/pitch and heading compensation. No need for calibration to determine roll, pitch and heading alignments.
  • Impact Subsea ISS360 Compact Imaging Sonar Equipment to supply a small and portable Compact Imaging scanning sonar system. Comes with a titanium instrument, 0.5-meter interface whip, USB drive with SeaView configuration software and user manual, quick start guide, and transit case.
  • Impact Subsea ISS360 Compact Imaging Sonar Equipment rental to supply a small and portable Compact Imaging scanning sonar system. Comes with a titanium instrument, 0.5-meter interface whip, USB drive with SeaView configuration software and user manual, quick start guide, and transit case.
  • Equipment rental to supply an Innomar Medium-100 USV Sub-Bottom Profiler. Comes with topside interface with OUT PC, pole mountable transducer with 15-meter deck cable, accessory kit, SES-WIN control software, mounting hardware, and transit cases.
  • The Compact Vessel of Opportunity kit is everything you need to add a Compact Sonar Mount to your vessel without the need to weld onto or drill through your gunnel. The VOOP kit can be configured in endless ways, using various extensions, supports and clamps.
  • Included Features

    • Heave / Roll beam stabilization
    • 24-bit SLF full waveform data acquisition / Innomar "SES3" data format
    • Multi-ping mode for maintaining a high pulse rate in deep waters
    • Multi-frequency signals
    • LFM chirp (2 – 7 kHz)
    • KVM extender for remote control
    • SESWIN basic remote-control via COM / UDP (e.g. line start/stop, line name)
    • Transducer frame with integrated shock absorbers for hull-mounting
  • HYPACK LITE: is the data collection and processing software for all the sensors supported by SURVEY. LITE includes data collection aspects from SURVEY, with the addition of processing tools for the same sensor suite. The data products from LITE can be exported to CAD or GIS.

Title

Go to Top